1、屋面防水一般的施工工序
驗收找平層→清理基層→配制水泥粘合劑→做附加層→基層施工→保護層→養護。卷材鋪設粘結前，先將屋面防水卷材預鋪開，找正，然后將屋面防水卷材兩端對折卷起，把配制好的水泥粘合劑倒入基層上，并用刮板均勻的刮開，再將屋面防水卷材向前推鋪，并及時用刮板排除遺留在屋面防水卷材內部的空氣，刮出多余粘結劑。屋面防水卷材與找平層的粘結率≥85%。
Acceptance leveling layer → → formulated to clean the grassroots do an additional layer of cement binder → → → Base Construction protective layer → conservation. Before laying the adhesive sheet, the first pre-roll roofing membrane, alignment, and then fold the ends of the roof waterproofing membrane rolled, the preparation of a good cement adhesive poured onto the grass roots, and even with a scraper scratch, and then push forward roofing membrane shop, and promptly left on the roof with a scraper to exclude the air inside the waterproof membrane, scraped off the excess
adhesive. Bond rate roofing membrane and leveling layer ≥85%.
2、屋面防水接縫施工：隔汽層、防水層和附加層均采用搭接縫方法，用水泥粘合劑粘結，寬度為10cm。附加層接縫與防水層接縫錯開5cm以上。屋面防水卷材搭接寬度長邊8-10cm，短邊10-15cm，相鄰短邊接縫應錯開100cm以上，墻面與地面夾角處均為30cm以上。
Seam roofing construction: vapor barrier, waterproof layer and the additional layer are made of lap joint approach with cement adhesive bonding, a width of 10cm. Additional layer seams and waterproof layer joints staggered more than 5cm. Roofing waterproofing membrane lap width of the long side 8-10cm, short side 10-15cm, adjacent short side seams should be staggered over 100cm,walls and floor are at an angle of more than 30cm.
3、卷材鋪粘完畢后，需在防水層上做1：2.5水泥砂漿厚度為2cm的保護層，分二次抹成，二層接茬必須錯開20cm以上，保護層要求平整，并灑水養護。
After completion of sticky web shop, you need to do on a waterproof layer: 2.5 cement mortar protective layer thickness of 2cm, divided into secondary wipe, floor Jiecha must be staggered more than 20cm, the protective layer should be smooth and sprinkler maintenance.
4、使用無紡布降低防水層受結構運動作用，加一條泡過柔韌型防水漿料的無紡布在裂縫處。
Waterproof layer by reducing the use of non-woven structure of sports action, plus a flexible waterproofing slurry bubble nonwovens in the cracks.
5、做水泥砂漿保護層，用水泥砂漿在干固后的防水層上涂刷做保護層。
A protective layer made ??of cement mortar with cement mortar on waterproof layer to dry brushing after doing a protective layer.
